4soft offers more than two hundred prefabricated graphics in EPDM. Wet pour graphics come in different shapes, sizes and designs. The thickness of these graphics is always 10 mm. The products are made from high quality EPDM and polyurethane binder.

JUST GLUE THE GRAPHIC COMPONENT ON THE SBR LAYER OR DIRECTLY ON CONCRETE. TAKE A LOOK AT OUR SIMPLE INSTALLATION GUIDES. WORKING WITH 3D GRAPHICS IS VERY EASY. JUST GLUE THEM !

Step 1

01 | Tools needed to measure the requested graphic and the material for gluing.

Step 2

02 | Measure and copy the graphic on a cured SBR layer along with the requested design.

Step 3

03 | Mix properly the two-component glue. Use standard PU glue for artificial grass. Use the two-component glue for larger patterns or more graphics.

Step 4

04 | Spread the glue evenly on the underside of your graphic.

Step 5

05 | Make sure the glue is spread evenly and to the edge!!!

Step 6

06 | Place the graphic exactly and press it properly to improve the glue distribution.

Step 7

07 | Apply the thick binder on the outside edges of the component to avoid their separation from the rest of the EPDM on the top layer.

Step 8

08 | Spread and compress your final EPDM layer properly around the component.

 

WARNING: BE CAREFUL ABOUT THE UPPER SIDE OF THE COMPONENT TO AVOID STAINING BY THE BINDER.

4soft